Label / Make
Genre / Model
- Please Select
- Name: A to Z
- Name: Z to A
- Price: Low to High
- Price: High to Low
AmpsandSound Bigger Ben Amplifier
Have a question about this product? Please email our audio advisor or call 1-877-929-8729 with any questions or concerns regarding your equipment purchase.
AmpsandSound Products Are Handmade In Small Batches and Go Through Extensive Quality Control
The draw of single-ended amplifiers has always been a level of engagement that other amplifiers often fail to deliver; well designed single-ended amplifiers are not only impressive in the midrange, but across all frequencies.
The Bigger Ben is designed to offer transparency, rich detail, and an incredibly low noise floor. Parts selection was crucial during the design process and each was chosen not for price, but for the level of synergy between parts. Rectification is solid state which permits cooler operation and reliable performance. The amp is configured for ultra-linear operation allowing greater power output and minimal use of feedback.
The amplifier features an extremely stiff power supply; significantly larger than needed for primary filtering. In the early days of tube amps, chokes were easier to come by than caps and more reliable. As such, large chokes were utilized for primary filtering. As capacitor production gained reliability and costs came down, cap filtering and smaller chokes became the norm. In a single-ended design, a regulated and extremely quiet power supply is very important. Using a large 5 Henry choke is expensive, but yields significant improvements in reduction of DC ripple.
The chosen output transformers are over-spec’d and the highest quality. Ampsandsound considers the output transformer as important as any other design choice. When buying any tube amplifier, the weight of the output transformer can be directly proportional to the quality of sound. In general, larger outputs have more massive cores which are less prone to saturation and have higher inductance.
Larger cores and greater inductance allow the transformer to carry a low-end signal with minimal distortion. These transformers are bench tested to perform down to 20hz and up to 20khz. Even if your speakers only go to 50hz like a classic LS3/5 two-way, having an amplifier able to drive that low is pivotal in recreating the whole soundstage.
Choice of Loudspeaker?
The Bigger Ben pairs well with most speakers 94db and above. However, Bigger Ben is so quiet it will perform beautifully with full-range or horn-loaded speakers of efficiency above 100db, 700 micro volts RMS noise at idle. Speakers that can go down cleanly to 30hz really bring out the very best of the amp. 20z-20khz -1db at full power. The Bigger Ben (depending on choice of output tubes) will output between 5-7 watts, but there’s a lot more in the tank than that when matched with appropriate loudspeakers.
The amp is compatible with all 6l6 family tubes, including the 6l6GC, KT66, KT77, KT88, KT90, and EL34s. The driver tube is a 6SL7.$2,800.00Single Ended Stereo Tube AmplifierBuy Now